CUSTOM 4 WAY WIRING HARNESS FOR TELECASTER®
The Obsidian® Custom Telecaster 4-Way wiring harness for adds a tasty fourth switch position to make your Tele scream. The neck and bridge pickups are able to work in series to provide a more powerful humbucker like tone. You can use this position for stronger rhythm and screaming leads. Fourth Position = Humbucker Mode ~ Requires Three Wire Neck Pickup Mod. Your Telecaster will retain all of the traditional switch positions, and the familiar master tone and volume controls.
TELECASTER 4 WAY SWITCH POSITIONS:
1: Neck & Bridge in Series (Humbucking)
2: Neck
3: Neck & Bridge in Parallel (Traditional Tele)
4: Bridge
SMOOTH CONTROL. An even tone and volume control taper all the way from zero to ten.
Obsidian® tone and volume controls incorporate carefully selected and custom-built components, as well as our own clever mods to smooth out the taper of your tone and volume controls, so you get a more even roll off all the way from zero to 10. Retain clarity at lower volumes. To make your tone crystal clear at lower volumes we include an Obsidian® Custom spec treble bleed mod. This prevents tone 'muddiness' at low volumes by allowing high frequencies to pass along a separate path to your amp, rather than being stopped short by the increasing resistance at the volume control.
Components:
- Potentiometers: Obsidian® Custom CTS® Pots 250K (+/-10%) - Solid Shaft 1/4"
- Capacitors: (150 Series Polyester Film 0.022UF) (+/-5%)
- Switch: Genuine Oak® 3 Way Switch
- Jack: Pure Tone® Mono Multi-Contact 1/4 in
Compatibility
Fits: Fender® US & MIM Telecaster® - Direct Fit // Right Hand Guitar Only
Fits: Fender® Japan Telecaster® - Replace control plate & knobs
Fits: Squier® Telecaster® - Replace control plate & knobs
Knobs: Requires US Spec 1/4" Solid Shaft Knobs
Control Plate: Use Genuine Fender or Obsidian® plate only - Other aftermarket plates will NOT fit
Pickups: Built for two single coil pickups. Requires three wire (2x ground & 1x hot) neck pickup or a three wire mod.
Wire instructions are provided, but a solder join is required..
Does NOT Fit: Thinline telecaster, or any guitar not specified above
Surfa in till Obsidians Produktsupport för manualer, installationstips och instruktioner. Klicka här. Öppnas i nytt fönster.
| 
