English Svenska
Meny
Varumärken
Nyheter
Mallfräs Hårdmetall D14 L25
Mallfräs Hårdmetall D14 L25
SEK:610:-
Mallfräs Hårdmetall D19 L25
Mallfräs Hårdmetall D19 L25
SEK:675:-
Mallfräs Hårdmetall D19 L10
Mallfräs Hårdmetall D19 L10
SEK:795:-

ColorTone Waterbase Clear Grain Filler

[SM-5577]
ColorTone Waterbase Clear Grain Filler

Finally, a clear grain filler that actually dries clear! It's not bluish or cloudy; ColorTone Clear Grain Filler is truly transparent when dry.

Apply it to raw wood, after sealer coats, or even between topcoats. It's compatible with all finishes and environmentally safe.

This waterbase filler dries much faster than messy old paste fillers: in 45 minutes it's ready for a second coat. We recommend two coats, and you can spray waterbase finish 1-2 hours after the filler goes on. (If you're spraying nitro, give it 12 hours before the finish coat.) Compare this to oil-base fillers which take days to dry.

  • Compatible with all finishes, including nitrocellulose and waterbase lacquers
  • Environmentally safe. Non-toxic, nonflammable, and solvent-free
  • Can be tinted with water-based stains or pigments
  • Easy to apply, dries fast and sands easily
  • Fills wood pores without sinking, shrinking or cracking

16-ounce (473ml) container

ColorTone Clear Grain Filler Instructions.

 


ColorTone waterbase grain filler is designed to fill the pores in any open grained woods such as ash, mahogany, rosewood, walnut, and koa. It will produce a smooth surface that will not shrink after finish is applied.

Unstained wood: Sand to 320-grit. Remove all dust and comtaminants. No sealer coat required. Use a brush to apply filler directly to bare wood, then use a squeegee to level the filler, working it in across the grain.

Stained wood: Seal the stain with two coats of clear lacquer and dry thoroughly. Sand to 320-grit. Use a brush to apply filler, then use a squeegee to level the filler, working it in across the grain.

Most woods require a second application for a complete fill. Let dry for 45 minutes and level-sand to 320-grit before repeating the process above. Allow 1-2 hours drying time before applying waterbase finishes, 12 hours for solvent based finishes.

KEEP OUT OF REACH OF CHILDREN
IMPORTANT: Keep from freezing. Do not apply below 60 F (15 C). Clean up with warm water. Do not ingest. May be harmful if swallowed. Always wear an OSHA approved dust mask when sanding.

FIRST AID: In case of eye contact, flush with water at least 15 minutes and seek medical attention if irritation persists. Wash material off skin with soap and water.
V.O.C. (minus water): less than 2.3 lbs/gal.

ColorTone Waterbase Clear Grain Filler      
 Recensioner 
SEK:595:-
Antal: 
Powered by Talex e-handelssystem